FR-Jersey-200C certified to EN 61482-1-2

May 2020 XM FireLine flame retardant fabric FR-Jersey-200C was tested and certified to EN 61482 (Live working. Protective clothing against the thermal hazards of an electric arc. Part 1-2).

Standard EN 61482-1-2:2014 is an equivalent to IEC 61482-1-2:2014. The main test of this standard is a Box test. It is used for  determination the behavior of fabrics against thermal risk when exposed to heat energy from electric arc with specific characteristics Materials performance for this procedure is determined from the amount of the heat transmitted through the specimen and other thermal parameters.

Determination of the protection class of the clothing depending on the level of intensity of the electrical installation, according to two classes:
Class 1 (4 kA during 0,5 s at 30 cm)
Class 2 (7 kA during 0.5 s at 30 cm)

During this test, a fabric sample is exposed to an electric Arc produced by a 4kA or 7kA short circuit. In the test, the Arc does not last any longer than 500ms. The amount of heat transmitted through the sample is measured during and after the test. On the basis of the resulting data and a Stoll curve, the length of time it would take to cause the onset of second-degree burns is subsequently determined. Samples are also assessed for after-flaming, hole formation, melting, etc.

The testing was done at independent international laboratory AITEX (Spain).

 

Requirements for the standard compliance EN 61482-1-2:2014
a) Burning time ≤ 5 s
b) No melting through to the inner side
c) No hole bigger than max. 5 mm in any direction in the innermost layer
d) All four pairs of values (Eit – tmax) are below corresponding Stoll values, and all four heat curves Eit (t) of transmitted energy are at any moment of time “t” of the exposure period below Stoll curve

 FR-Jersey-200C test results (after 5 washing cycles at 600C)

  • Burning time: 0,0s – PASS
  • Melting through to the inner side: No – PASS
  • Hole formation > 5mm: No – PASS
  • All four specimens of tested fabric are below Stoll curve – PASS

Live working – Protective clothing against the thermal hazards of an electric arc – Part 1-2: Test methods – Method 2: Determination of arc protection class of material and clothing by using a constrained and directed arc (box test) – (EN 61482-1-2:2014, FOR CLASS 1) – PASS

CATEGORY OF ARC THERMAL PROTECTION ACCORDING TO EC 61482-2:2018 – APC 1 (Class 1)
The arc protection class is characterized by the test energy level of arc exposure (arc energy and incident energy)

 

Flame retardant fabric FR-Jersey-200C is used for fr base layer (FR underwear). This FR knitted fabric with Antistatic properties helps to increase fr protection when weared under fr clothing (fr-jacket and fr-pants).
You can find additional information on the FR-Jersey-200C product page.

ti is the time where the difference between the transmitted incident energy Eit and the Stoll Energy EiSTOLL is maximum.
Interpretation: In negative value, a higher difference implies a better behavior. In positive value, a less difference implies a better behavior, taking into account that the material fails the test.